Everything below concerns stoichiometry. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-02-17. Where a claim depends on a specific study, the study is described rather than over-claimed.
Several names circulate for the same material, which complicates literature searches. Cosmetic ingredient lists often use copper tripeptide-1, while older biochemistry papers use glycyl-L-histidyl-lysine or its abbreviation GHK. The copper complex is sometimes written as GHK-Cu(II) to make the oxidation state explicit. Terminology is not fully standardized, so matching a compound across sources requires attention to the exact sequence, the counterion, and the stated copper content. Reviews that compare studies must account for these naming differences before drawing conclusions.
GHK-Cu is the copper(II) complex of the tripeptide glycyl-L-histidyl-L-lysine, a short sequence of three amino acids. The peptide was first isolated from human plasma in 1973 during research on factors that influence tissue repair in liver. Its ability to bind copper ions became a central point of interest because the metal changes the peptide's chemistry and its behaviour in laboratory systems. Today the compound appears in cosmetic formulations, cell-culture studies, and biochemistry literature under several names.
Identity and purity are normally checked by reversed-phase high-performance liquid chromatography, often coupled to mass spectrometry. The peptide absorbs in the ultraviolet region, and the copper complex also shows a broad visible absorption band that can be followed spectroscopically. Copper content is measured separately, for example by inductively coupled plasma mass spectrometry or atomic absorption spectroscopy, because the peptide assay alone does not confirm how much metal is bound. Purity figures therefore need a stated basis: peptide peak area, copper content, or both.
Aqueous GHK-Cu solutions are less stable than the dry powder. Light, dissolved oxygen and elevated temperature all accelerate loss of the intact complex, and the main observable changes are fading of the blue colour and the appearance of peptide fragments. Acidic conditions protonate the histidine imidazole and weaken copper binding, while strongly alkaline conditions promote hydrolysis of the peptide backbone. Because several degradation routes operate at once, a single shelf-life figure does not describe all storage conditions.
Solid material is typically kept as a lyophilised powder in a sealed, light-protected container at minus 20 degrees Celsius, with desiccant where humidity is high. Working solutions are often prepared fresh, aliquoted and frozen to avoid repeated freeze-thaw cycles. Glassware and buffers are checked for trace metal contamination, since other transition metals can displace copper. Records of lot number, reconstitution date and storage temperature help trace unexpected colour changes. Blue colour itself is not a reliable purity test, because partly degraded solutions can remain visibly coloured.
| Property | Value | Notes |
|---|---|---|
| Peptide sequence | Gly-His-Lys | Three amino acids, histidine in the middle |
| Complex formula | C14H22CuN6O4 | One copper(II) ion per peptide |
| Molar mass (complex) | approx. 402.9 g/mol | Depends on counterion and hydration state |
| Appearance | Blue to blue-violet solid | Colour arises from copper coordination |
| Common synonyms | Copper tripeptide-1, GHK-Cu | Naming varies between disciplines |
Practical handling notes centre on limiting exposure to water, oxygen, and repeated temperature cycling. Weighed powder is often equilibrated to room temperature before opening to avoid condensation on the solid. Working solutions are typically divided into single-use aliquots and frozen rather than stored refrigerated for long periods. Reported shelf lives vary widely between laboratories, and no single set of conditions is universally treated as a reference standard, which complicates direct comparison of published stability figures.
Solutions of GHK-Cu respond strongly to pH, redox conditions, and the presence of competing chelators such as EDTA. Below roughly pH 4 the copper tends to dissociate, because the amide nitrogen donors become protonated and can no longer coordinate. Strongly alkaline conditions instead favour hydrolysis and precipitation of copper hydroxide. Dissolved oxygen and light accelerate breakdown of the peptide backbone, and the copper released during that process can catalyse further oxidation, so dry, cold, dark storage is the usual recommendation.
Routine characterisation relies on reversed-phase high-performance liquid chromatography for peptide purity, paired with mass spectrometry for identity confirmation. Ultraviolet-visible spectroscopy detects the metal centre through its absorption band in the visible region, and inductively coupled plasma mass spectrometry quantifies total copper so that a metal-to-peptide ratio can be calculated. Amino acid analysis confirms the expected residue composition. Together these techniques establish concentration, identity, and stoichiometry, but none of them directly reports biological activity.
The International Nomenclature of Cosmetic Ingredients lists the substance as copper tripeptide-1, the name that appears on most topical product labels. Related designations include copper peptide and GHK-Cu, and the hyphenated form is common in research literature. In cosmetics the material is regulated as an ingredient rather than as a drug, so products may reach the market without evidence of the effects claimed for them. Whether those effects are clinically meaningful is an open question, since most supportive data come from laboratory work and small trials.
GHK-Cu is the copper complex of the tripeptide glycyl-L-histidyl-L-lysine, a short sequence found naturally in human plasma, saliva and urine. Loren Pickart reported the isolation of the free peptide in 1973 while studying factors that influenced the growth of aged liver cells in culture. The peptide was later shown to bind copper(II) with high affinity, and the metal-bound form became the focus of most subsequent research. Its concentration in circulation declines markedly with age, a pattern that is well documented, though the physiological consequences of that decline remain debated.
The peptide portion consists of three amino acids: glycine, histidine and lysine. Copper(II) coordinates through the imidazole nitrogen of histidine, the alpha-amino group of glycine and a deprotonated amide nitrogen of the backbone, producing a roughly square-planar geometry. This arrangement gives the complex its characteristic blue-to-violet colour and helps it resist dissociation in water. Reported stability constants are high, although values differ between studies because of differences in ionic strength and measurement method.
Quality control for GHK-Cu relies on documentation and independent testing rather than a single accepted standard. A certificate of analysis may report peptide purity, copper content, residual solvents, water content, and microbial limits, but the underlying methods and acceptance criteria vary by supplier. Verification can include mass confirmation, amino acid analysis, and comparison with a reference standard when one is available. Open questions include how different copper-binding modes or peptide isomers affect measured activity and whether conventional purity assays capture those differences. Buyers of research-grade material typically need to request raw data rather than rely solely on a summary certificate.
Laboratory characterization of GHK-Cu typically combines separation, spectroscopic, and elemental techniques. Reverse-phase high-performance liquid chromatography is widely used to assess peptide purity, often with ultraviolet detection near the copper-related absorption band or with mass spectrometry for identity confirmation. Because the molecule contains copper, elemental methods such as inductively coupled plasma mass spectrometry or atomic absorption spectroscopy are used to quantify metal content and confirm stoichiometry. No single universal pharmacopeial monograph exists for GHK-Cu. Laboratories therefore validate their own methods, and reported purity values depend on the chosen assay and calibration standards.
Stability of GHK-Cu is influenced by light, oxygen, moisture, pH, and temperature. Solid material is generally kept desiccated and frozen to reduce hydrolysis and oxidation, while aqueous solutions are best prepared fresh or stored cold in aliquots. Repeated freeze-thaw cycles can promote aggregation, precipitation, or peptide degradation. Copper coordination may change under strongly acidic or alkaline conditions, potentially altering the complex's spectroscopic properties. Published long-term stability data for specific matrices, such as cosmetic emulsions or biological buffers, are limited, so shelf-life claims should be treated as formulation-specific rather than universal.
Pizza Hut has sponsored the Book It! reading-incentive program since it started in January 1985. Students who read books according to the goal set by the classroom teacher, in any month from October through March, are rewarded with a Pizza Hut certificate good for a free, one-topping Personal Pan Pizza; and the classroom whose students read the most books is rewarded with a pizza party. A 1987 report estimated that children participating in the program increased their reading from three books to nine books per month, on average. The success of the classroom-based reading encouragement program spurred local libraries to create their own reading program during the summer months, when school is not in session. Book It! was conceived in 1984 during a dinner with Art Gunther, President of Pizza Hut, and Bud Gates, SVP of Marketing at Pizza Hut, as a way to help Gunther's son read more. The program has been criticized by some psychologists on the grounds it may lead to overjustification and reduce children's intrinsic interest in reading. Book It! was also criticized by the Campaign for a Commercial-Free Childhood in 2007 who described it as "one of corporate America's most insidious school-based brand promotions." A pamphlet produced by the group argued the program promoted junk food to a captive market, made teachers into promoters for Pizza Hut, and undermined parents by making visits to the chain an integral part of bringing up their children to be literate. However, a study of the program found participation in the program neither increased nor decreased reading motivation.
== External links == "P2Y Receptors: P2Y1". IUPHAR Database of Receptors and Ion Channels. International Union of Basic and Clinical Pharmacology. Archived from the original on 2016-03-03. Retrieved 2008-12-09. This article incorporates text from the United States National Library of Medicine, which is in the public domain.
Radon is a colorless, odorless, and tasteless gas and therefore is not detectable by human senses alone. At standard temperature and pressure, it forms a monatomic gas with a density of 9.73 kg/m3, about 8 times the density of the Earth's atmosphere at sea level, 1.217 kg/m3. It is one of the densest gases at room temperature (a few are denser, e.g. CF3(CF2)2CF3 and WF6) and is the densest of the noble gases. Radon is colorless at standard temperature and pressure. When cooled below its boiling point of 211.5 K (−61.6 °C; −79.0 °F), concentrated liquid radon emits radioluminescence of varying color; solidified radon emits a blue to yellow to red light when cooled further beyond its freezing point of 202 K (−71 °C; −96 °F). Due to the hazards associated with high concentrations of radon, liquid and solid radon is almost never seen. Measurements of the solubility of radon-222 are unusual in that they take advantage of radon's radioactivity to compare the amount in gas and in solution.
== History == The concept of residence time originated in models of chemical reactors. The first such model was an axial dispersion model by Irving Langmuir in 1908. This received little attention for 45 years; other models were developed such as the plug flow reactor model and the continuous stirred-tank reactor, and the concept of a washout function (representing the response to a sudden change in the input) was introduced. Then, in 1953, Peter Danckwerts resurrected the axial dispersion model and formulated the modern concept of residence time.
==== Specialized substitution matrices and their extensions ==== The real substitution rates in a protein depends not only on the identity of the amino acid, but also on the specific structural or sequence context it is in. Many specialized matrices have been developed for these contexts, such as in transmembrane alpha helices, for combinations of secondary structure states and solvent accessibility states, or for local sequence-structure contexts. These context-specific substitution matrices lead to generally improved alignment quality at some cost of speed but are not yet widely used. Since the 2000s, an increasing amount of matrices are defined for subsets of proteins not optimally aligned by traditional "general-purpose" matrices. These include:
Sources: en.wikipedia.org
However, the "absolute zero" on the Kelvin temperature scale was originally defined in terms of the second law of thermodynamics, which Thomson himself described in 1852. Thomson did not assume that this was equal to the "zero-volume point" of Charles's law, merely said that Charles's law provided the minimum temperature which could be attained. The two can be shown to be equivalent by Ludwig Boltzmann's statistical view of entropy (1870). However, Charles also stated:
== History == Thyroxine was first isolated in pure form in 1914 at the Mayo Clinic by Edward Calvin Kendall from extracts of hog thyroid glands. The hormone was synthesized in 1927 by British chemists Charles Robert Harington and George Barger.
==== England (1920, 1923, 1925, 1935, 1938, 1946) ==== Constance Long arranged for Jung to deliver a seminar in Cornwall in 1920. Another seminar was held in 1923, this one organized by Jung's British protégé Helton Godwin Baynes (known as "Peter") (1882–1943), and another in 1925.
==== Winter ==== Traditionally, the greatest varieties of kimchi were available during the winter. In preparation for the long winter months, many types of kimjang kimchi (김장 김치) were prepared in early winter and stored in the ground in large kimchi pots. Today, many city residents use modern kimchi refrigerators offering precise temperature controls to store kimjang kimchi. November and December are traditionally when people begin to make kimchi; women often gather together in each other's homes to help with winter kimchi preparations. "Baechu kimchi" is made with salted baechu filled with thin strips of radish, parsley, pine nuts, pears, chestnuts, shredded red pepper, manna lichen (Korean: 석이 버섯; RR: seogi beoseot), garlic, and ginger.
protein–protein relationships are often the result of multiple types of interactions or are deduced from different approaches, including co-localization, direct interaction, suppressive genetic interaction, additive genetic interaction, physical association, and other associations.
Sources: en.wikipedia.org
The peptide is glycyl-L-histidyl-L-lysine, a three-amino-acid sequence commonly abbreviated GHK. It binds a single copper(II) ion under typical laboratory conditions. The free peptide and the copper complex are separate chemical species with different properties.
The sequence was identified in human plasma in 1973. Early work examined its presence in blood and its proposed role in tissue repair. The copper-binding property was characterized afterward and became the focus of much later research.
The tripeptide has been measured in human plasma and other biological fluids. Whether it circulates mainly as the copper complex or as the free peptide remains an open question. Natural concentrations are low and difficult to measure reliably.
The colour depends on copper held in a specific coordination environment. When the complex dissociates or the peptide is cleaved, that environment changes and the visible absorption weakens.