Chelation is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-01-27. Where a claim depends on a specific study, the study is described rather than over-claimed.
The compound was first isolated from human plasma in the 1970s by Loren Pickart, who later described copper-binding activity in liver and other tissues. Early reports focused on its presence in blood and its ability to carry copper between proteins. Commercial and cosmetic use of the term 'copper peptide' has since broadened, and labels rarely distinguish GHK-Cu from other copper-binding fragments. This naming overlap makes literature searching harder, because cosmetic ingredient lists, supplier catalogues and laboratory papers use different vocabularies for the same molecule.
GHK-Cu is the copper-binding complex formed by the tripeptide glycyl-L-histidyl-L-lysine and a copper(II) ion. The free peptide is usually written as GHK, and the complex is written as GHK-Cu or Cu-GHK. The sequence was identified in human plasma and later detected in saliva and urine. Its name comes from the single-letter codes of glycine, histidine and lysine. The complex is widely described as a naturally occurring carrier of copper in blood rather than as a free peptide with its own hormonal role.
Identity and purity are assessed mainly by reversed-phase high-performance liquid chromatography with ultraviolet detection, often paired with mass spectrometry to confirm the expected mass. Copper content is measured separately by inductively coupled plasma optical emission spectrometry or atomic absorption spectroscopy, because the peptide assay alone does not establish the metal-to-peptide ratio. Visible spectroscopy provides a rapid check on complex integrity through the absorption band in the visible region. Agreement between the peptide assay and the copper assay is the practical test of whether a sample is the intended complex rather than a mixture.
Aqueous solutions of GHK-Cu are less stable than the dry powder. The peptide backbone is vulnerable to hydrolysis at extreme pH, and copper can be stripped from the complex by strong chelating agents such as EDTA or citrate. Oxidising agents and high concentrations of ascorbic acid can reduce copper(II) and change the complex, which is one reason formulators often keep such ingredients in separate phases. How quickly these changes occur under real storage conditions depends on pH, buffer, temperature and packaging, and quantitative data on the subject are limited.
Dry material is normally held cold, commonly at -20 °C for long-term storage and 2 to 8 °C for working quantities, protected from light and moisture. Vials should be allowed to reach room temperature before opening so that condensation does not form on the powder. In liquid formulations the complex is generally kept near neutral to slightly acidic pH, because strongly alkaline conditions favour precipitation of copper hydroxide. Antioxidants or chelate-stabilising excipients are often added, though the specific approaches are proprietary and rarely published in detail.
| Property | Value | Notes |
|---|---|---|
| Sequence | Gly-His-Lys | Three amino acids; histidine supplies the main copper-binding nitrogen |
| Bound metal | Copper(II) | Coordination is described as square-planar around the metal centre |
| Appearance | Blue to violet solid | Colour originates from copper d-d electronic transitions |
| Solubility class | Freely soluble in water | Aqueous solutions are often slightly acidic |
| Common synonyms | Copper tripeptide, Cu-GHK | Ingredient lists may say only 'copper peptide' without giving the sequence |
Dry material is typically held at low temperature, often around minus twenty degrees Celsius, and protected from moisture and light. Copper complexes can release their metal ion under acidic conditions or in the presence of competing chelators. Hydrolysis of the peptide backbone is a slower but real pathway, and the histidine residue is susceptible to oxidation over long periods. Stability statements therefore depend on formulation, pH, and container, and they should be read as conditional rather than absolute.
Identity and purity are usually assessed with reversed-phase high-performance liquid chromatography, often paired with mass spectrometry. Copper content is measured separately by techniques such as inductively coupled plasma mass spectrometry or atomic absorption. Amino acid analysis confirms the peptide sequence after hydrolysis. Because the metal and the peptide can be quantified independently, a complete certificate of analysis normally reports both values rather than a single purity figure. This separation of measurements is important when comparing suppliers.
Solid GHK-Cu appears as a blue to blue-violet powder, and the colour is a direct consequence of copper coordination. The complex dissolves readily in water and in many polar solvents, while the free peptide behaves differently. Solubility in nonpolar media is low, which limits its use in oil-based systems. Solutions are typically prepared fresh because the dissolved form is more exposed to hydrolysis and to loss of the metal ion than the dry powder. Working concentrations are usually low, and preparation notes often specify the solvent and the order of addition.
Published work on GHK-Cu is dominated by in vitro experiments and small animal studies. Human trials tend to be short and small, with endpoints such as skin appearance rather than clinical outcomes. Review articles often summarize the same underlying laboratory findings, which can make the evidence base look broader than it is. Several basic questions remain open: the concentration of the intact complex in human tissue, the route by which it crosses the skin barrier, and whether effects seen in culture produce measurable changes in people.
Laboratory studies describe GHK-Cu as a source of copper that cells can take up, with reported effects on collagen, elastin, and glycosaminoglycan synthesis in cultured fibroblasts. The peptide also appears in wound-repair research, where it is linked to the activity of matrix metalloproteinases and their inhibitors. These observations come largely from cell and animal models. How directly the complex controls any single pathway in intact human skin remains an open question, and reported effects depend on concentration, vehicle, and exposure time.
The International Nomenclature of Cosmetic Ingredients lists the substance as copper tripeptide-1, the name that appears on most topical product labels. Related designations include copper peptide and GHK-Cu, and the hyphenated form is common in research literature. In cosmetics the material is regulated as an ingredient rather than as a drug, so products may reach the market without evidence of the effects claimed for them. Whether those effects are clinically meaningful is an open question, since most supportive data come from laboratory work and small trials.
GHK-Cu is the copper complex of the tripeptide glycyl-L-histidyl-L-lysine, a short sequence found naturally in human plasma, saliva and urine. Loren Pickart reported the isolation of the free peptide in 1973 while studying factors that influenced the growth of aged liver cells in culture. The peptide was later shown to bind copper(II) with high affinity, and the metal-bound form became the focus of most subsequent research. Its concentration in circulation declines markedly with age, a pattern that is well documented, though the physiological consequences of that decline remain debated.
==== Elimination ==== Instead of by hepatic metabolism, atenolol is eliminated from the blood mainly via renal excretion. Atenolol is excreted about 40 to 50% in urine and 50% in feces with oral administration. Conversely, it is excreted 85 to 100% in urine unchanged and 10% in feces with intravenous administration. Only very small amounts of hydroxyatenolol and atenolol glucuronide are found in urine with atenolol. The elimination half-life of atenolol is about 6 to 7 hours. The half-life of atenolol does not change with continuous administration. With intravenous administration, atenolol levels rapidly decline (5- to 10-fold) during the first 7 hours and thereafter decline at a rate similar to that with oral administration. The elimination of atenolol is slowed in renal impairment, with the elimination rate being closely related to the glomerular filtration rate (GFR) and with significant accumulation occurring when the creatinine clearance rate is under 35 mL/min/1.73 m2. At a GFR of less than 10 mL/min, the half-life of atenolol increases up to 36 hours.
Finally, rapG and rapH have been identified to code for enzymes that have a positive regulatory role in the preparation of rapamycin through the control of rapamycin PKS gene expression. Biosynthesis of this 31-membered macrocycle begins as the loading domain is primed with the starter unit, 4,5-dihydroxocyclohex-1-ene-carboxylic acid, which is derived from the shikimate pathway. Note that the cyclohexane ring of the starting unit is reduced during the transfer to module 1. The starting unit is then modified by a series of Claisen condensations with malonyl or methylmalonyl substrates, which are attached to an acyl carrier protein (ACP) and extend the polyketide by two carbons each. After each successive condensation, the growing polyketide is further modified according to enzymatic domains that are present to reduce and dehydrate it, thereby introducing the diversity of functionalities observed in rapamycin (figure 1). Once the linear polyketide is complete, L-pipecolic acid, which is synthesized by a lysine cycloamidase from an L-lysine, is added to the terminal end of the polyketide by an NRPS. Then, the NSPS cyclizes the polyketide, giving prerapamycin, the first enzyme-free product. The macrocyclic core is then customized by a series of post-PKS enzymes through methylations by MTases and oxidations by P-450s to yield rapamycin.
=== Other methods === Burning sulfur together with saltpeter (potassium nitrate, KNO3), in the presence of steam, has been used historically. As saltpeter decomposes, it oxidizes the sulfur to SO3, which combines with water to produce sulfuric acid. Prior to 1900, most sulfuric acid was manufactured by the lead chamber process. As late as 1940, up to 50% of sulfuric acid manufactured in the United States was produced by chamber process plants. A wide variety of laboratory syntheses are known, and typically begin from sulfur dioxide or an equivalent salt. In the metabisulfite method, hydrochloric acid reacts with metabisulfite to produce sulfur dioxide vapors. The gas is bubbled through nitric acid, which will release brown/red vapors of nitrogen dioxide as the reaction proceeds. The completion of the reaction is indicated by the ceasing of the fumes. This method conveniently does not produce an inseparable mist.
== Public health == Public health, health aid, and medical research are the most prominent areas of work of the foundation. On December 5, 1913, the Board made its first grant of $100,000 to the American Red Cross to purchase property for its headquarters in Washington, D.C. The foundation established the Johns Hopkins School of Public Health and Harvard School of Public Health, two of the first such institutions in the United States, and established the School of Hygiene at the University of Toronto in 1927, and the London School of Hygiene and Tropical Medicine in the United Kingdom. they spent more than $25 million in developing other public health schools in the US and in 21 foreign countries. In 1913, it also began a 20-year support program of the Bureau of Social Hygiene, whose mission was research and education on birth control, maternal health and sex education. In 1914, the foundation set up the China Medical Board, which established the first public health university in China, the Peking Union Medical College, in 1921; this was subsequently nationalized when the Communists took over the country in 1949. In the same year it began a program of international fellowships to train scholars at many of the world's universities at the post-doctoral level. The Foundation also maintained a close relationship with Rockefeller University (also known as the Rockefeller Institute for Medical Research) with many faculty holding overlapping positions between the institutions.
== External links == "Relaxin Family Peptide Receptors: RXFP2". IUPHAR Database of Receptors and Ion Channels. International Union of Basic and Clinical Pharmacology. Archived from the original on 2016-03-03. Retrieved 2008-12-09. This article incorporates text from the United States National Library of Medicine, which is in the public domain.
Sources: en.wikipedia.org
== External links == Ciliary+neurotrophic+factor at the U.S. National Library of Medicine Medical Subject Headings (MeSH) Overview of all the structural information available in the PDB for UniProt: P26441 (Ciliary neurotrophic factor) at the PDBe-KB.
=== Investigations regarding tipping points === The ENSO is considered to be a potential tipping element in Earth's climate. Global warming can strengthen the ENSO teleconnection and resulting extreme weather events. For example, an increase in the frequency and magnitude of El Niño events have triggered warmer than usual temperatures over the Indian Ocean, by modulating the Walker circulation. This has resulted in a rapid warming of the Indian Ocean, and consequently a weakening of the Asian Monsoon.
All mammalian alkaline phosphatase isoenzymes except placental (PALP and SEAP) are inhibited by homoarginine, and, in similar manner, all except the intestinal and placental ones are blocked by levamisole. Phosphate is another inhibitor which competitively inhibits alkaline phosphatase. Another known example of an alkaline phosphatase inhibitor is [(4-Nitrophenyl)methyl]phosphonic acid. In metal contaminated soil, alkaline phosphatase are inhibited by Cd (Cadmium). In addition, temperature enhances the inhibition of Cd on the enzyme activity, which is shown in the increasing values of Km. In humans, alkaline phosphatase is present in all tissues throughout the body, but is particularly concentrated in the liver, bile duct, kidney, bone, intestinal mucosa and placenta. In the serum, two types of alkaline phosphatase isozymes predominate: skeletal and liver. During childhood the majority of alkaline phosphatase are of skeletal origin. Humans and most other mammals contain the following alkaline phosphatase isozymes:
The sample is assumed to have originally had the same 14C/12C ratio as the ratio in the atmosphere, and since the size of the sample is known, the total number of atoms in the sample can be calculated, yielding N0, the number of 14C atoms in the original sample. Measurement of N, the number of 14C atoms currently in the sample, allows the calculation of t, the age of the sample, using the equation above. The half-life of a radioactive isotope (usually denoted by t1/2) is a more familiar concept than the mean-life, so although the equations above are expressed in terms of the mean-life, it is more usual to quote the value of 14C's half-life than its mean-life. The currently accepted value for the half-life of 14C is 5,700 ± 30 years. This means that after 5,700 years, only half of the initial 14C will remain; a quarter will remain after 11,400 years; an eighth after 17,100 years; and so on. The above calculations make several assumptions, such as that the level of 14C in the atmosphere has remained constant over time. In fact, the level of 14C in the atmosphere has varied significantly and as a result, the values provided by the equation above have to be corrected by using data from other sources. This is done by calibration curves (discussed below), which convert a measurement of 14C in a sample into an estimated calendar age.
Sources: en.wikipedia.org
The letters GHK are the one-letter codes for glycine, histidine and lysine, the three amino acids in the peptide. The suffix Cu indicates that the peptide is bound to a copper ion, normally copper(II).
The free tripeptide and its copper complex have been measured in human plasma, saliva, urine and some tissue extracts. Reported concentrations vary widely between studies, and the role of the complex in normal physiology remains partly unresolved.
The plain peptide lacks the metal, so its charge, colour and binding behaviour differ. The copper complex is blue and carries a bound copper ion, while the metal-free form is colourless and has different solution chemistry.
Dry powder is best kept cold, dark and sealed, typically at -20 °C for long-term storage or 2 to 8 °C for material in regular use. Vials should be warmed to room temperature before opening to prevent moisture condensing on the contents. Aqueous stock solutions degrade faster and are usually prepared fresh.